Get help or lend some...
Gen 1 Gen 2 BKing
Well.... Not often in the mechanical world..... but it all comes clear today. There are TWO (2) types of Phillips head screws..US and Japanese (JIS)...
I need to replace the oil pan gasket this winter.. boo!! :frown: Where is the best/ cheapest place to buy said gasket? :headscratch:
Just need a little help on diagnosing this problem Im having. My bike makes this strange noise like my chain is grinding on the sprockets of my...
From "Performance Bikes" (Also as a 3 page pdf.)
From “RIDE” Magazine:
What's everone's favorite to wipe down the bike in between major cleanups? I've been looking for something but there are so many, I'm not sure which...
Who makes a decent (Accurate) pressure gauge? I have about 5 of them and they all give different readings, sometimes as much as 5PSI different. It's...
What is the best way to lower the engine out of hte frame by yourself? I have a floor jack, but the oil pan does not look like a good balanced...
I adjust my chain with an accurate adjusting tool. Here are how much the factory marks are out: Out by a little less than 1 full line. Too much...
Just wondering where others have sourced the M20x1.5 bolt needed to remove the generator rotor? I've called every store I thought would carry one and...
FYI Works great!
I installed one of these kits and it helped a lot! Here's how:
Here from my experience:
Here is a pdf, part from another site, part mine. The pictures were missing there, and I hunted them up, and did the work to make the pdf so I...
Lots of good info here. How To: http://www.onthethrottle.com/content/category/5/24/73/ Past Live Shows: ...
Dr E's Busa Backrest instruction doc... Originally when I first made this and posted it a year ago I had said I would email anyone who wanted the...
Well Winter Sucks but ... it is about time to put the winter air in the tires… a few things you might want to consider before storing the bike...
I made a set of these for on the road and to lube the chain easier.
hope this is in the right spot but i was just wondering how hard it is to change out the seals on my front forks my left one i believe might have...
Ok Rostra installed and "Working!" only caveat was the #10 dipswitch.. it needed to be off in my case as the control switch was an OPEN design.. ...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
